Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Exterior interior trim / Front bumper / Installation

CAUTION:

• Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a).

• Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, the flange section may be broken or the clearance between fender panel and bumper face may not be uniform.

1. Install the fog light assembly - front.

2. Install the bracket - front bumper side.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

3. Install the bracket - front bumper corner.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

4. Install the bracket - front center LWR.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

5. Install the under cover - front. Front Under Cover > REMOVAL

6. Install the bumper beam COMPL - front.

Tightening torque:

33 N·m (3.4 kgf-m, 24.3 ft-lb)

7. Install the active grille shutter. (H4 model)

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

8. Install the energy absorber foam - front.

9. Install the bumper face - front.

NOTE:

Secure the flange section of the bumper face - front to the bracket - front bumper side.

10. Connect the ground terminal to battery sensor. NOTE

11. Adjust the fog light beam. Front Fog Light Assembly > ADJUSTMENT

Repair

1. COATING METHOD FOR PP BUMPERProcess No.Process nameJob contents1Bumper installationPlace the bumper on a paint worktable as required. Use the paint worktable conforming to inner shape of bumper if ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the bumper face - front.(1) Remove the clips at the upper side of the bumper face - front.(2) Remove the clips from the fender.(3) ...

Other materials:

Installation
CAUTION:• Do not start the engine before charging refrigerant.• If the engine is started with no refrigerant charge, replace the compressor assembly.• Replace O-rings and pipe clamps with new parts and install securely.• Before handling the airbag system components, refer to ...