CAUTION: Make sure that there is a gasket attached on the clip of the garnish assembly. If a gasket is not attached, water leakage may occur. 1. Install the garnish assembly - rear gate. Tightening torque: 4.5 N·m (0.5 kgf-m, 3.3 ft-lb) 2. Install the cover - rear gate. Tightening torque: 1.5 N·m (0.2 kgf-m, 1.1 ft-lb) 3. Install the power rear gate touch sensor LWR. (Model with power rear gate) Power Rear Gate Touch Sensor > INSTALLATION 4. Install the rear gate trim. 5. Connect the ground terminal to battery sensor. NOTE |
Installation
1. EGR PIPE A1. Temporarily attach the EGR pipe A to the cylinder head and the EGR control valve.NOTE:Use a new gasket.2. Tighten the bolts securing the EGR pipe A to the EGR control valve.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)3. Lift up the vehicle.4. Tighten the bolts securing the ...