1. SEDAN MODEL CAUTION: If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat. 1. Install the trim panel - rear pillar UPR. 2. Install the side pad assembly - backrest. Tightening torque: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 3. Install the rear seat cushion assembly. 4. Connect the ground terminal to battery sensor. NOTE 2. OUTBACK MODEL CAUTION: If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat. 1. Install the rear quarter trim UPR. NOTE: Insert the claw of the rear quarter trim UPR - rear into the rear quarter trim UPR - front. 2. Install the trim panel - rear apron. 3. Install the mat - rear floor, box - sub trunk, and spacer - rear floor. 4. Remove the clips, and install the trim panel - rear skirt. 5. Install the side pad assembly - backrest. Tightening torque: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 6. Install the rear seat cushion assembly. 7. Connect the ground terminal to battery sensor. NOTE |
Dtc p013f o2 sensor delayed response - lean to rich bank 1 sensor 2
NOTE:For the diagnostic procedure, refer to DTC P013A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P013A O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 21. OUTLINE OF DIAGNOSISDetect the delayed response of rear oxygen sensor output for lean > rich.After the deceleration fue ...