Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • When removing or installing the roof rail, be careful not to scratch the body panel with the stud bolt of roof rail. • Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION • When removing and installing the curtain airbag module, observe the operation procedures in the “AIRBAG SYSTEM” section. • Do not reuse the clip securing the curtain airbag module. • Be careful not to damage the curtain airbag module during removal and installation. 1. Install the roof rail assembly. Tightening torque: Flange nut: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) Stopper bolt M6: 8 N·m (0.8 kgf-m, 5.9 ft-lb) Stopper bolt M8: 10 N·m (1.0 kgf-m, 7.4 ft-lb) 2. Install the curtain airbag module. Curtain Airbag Module > INSTALLATION 3. Install the roof trim. Roof Trim > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE |
Removal
NOTE:Remove the stopper bolt first when removing the crossbar assembly only.CAUTION:Refer to “CAUTION” of “General Description” before handling the airbag system components. G ...
Roof spoiler
...
Other materials:
Installation
1. SEDAN MODEL1. Replace the light assembly gasket with a new part.2. Install the light assembly - rear combination.CAUTION:Be careful not to catch the harness in between the parts.Tightening torque:4.5 N·m (0.5 kgf-m, 3.3 ft-lb)3. Install the trunk trim panel - side.4. Connect the ground ter ...
