CAUTION: • For installation of the stereo camera cover, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION • When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off. • Do not reuse the tether clip removed from the upper part of the trim panel - front pillar UPR. Always replace with a new part. • Before installing the trim panel - front pillar UPR, check the condition of protective non-woven fabric (white) of the curtain airbag. If it is damaged (airbag module cloth is exposed), replace the curtain airbag module assembly with a new part. • If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat. 1. Install the trim panel - roof assembly. (1) Bring the trim panel - roof assembly inside the vehicle. (2) Attach the feeder cord and roof cord to the roof trim. CAUTION: Route each cord carefully. The cord may interfere, thus preventing normal deployment of the curtain airbag when necessary. Tape: Item number: 86359SC000/TAPE NOTE: Use the tape (service parts) by cutting into 80 mm - 50 mm (3.1 in - 2.0 in).
(3) Secure the trim panel - roof assembly with the clips. 2. Install the garnish - roof. (Model with sunroof) 3. Install the assist rail. 4. Install the light assembly - room. 5. Install the sun visor assembly. Tightening torque: 2 N·m (0.2 kgf-m, 1.5 ft-lb) 6. Install the overhead console. (Models without EyeSight) 7. Install the stereo camera cover assembly. (Models with EyeSight) Stereo Camera > INSTALLATION 8. Install the trim panel - rear pillar UPR. 9. Install the upper inner trim. Tightening torque: Trim panel - center pillar UPR: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) Front seat belt anchor: 30 N·m (3.1 kgf-m, 22.1 ft-lb) 10. Install the lower inner trim. 11. Install the side pad assembly - backrest. Tightening torque: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 12. Install the rear seat cushion assembly. 13. Install the console box assembly and cover - shift lever. (Sedan model) Tightening torque: 6.5 N·m (0.7 kgf-m, 4.8 ft-lb) 14. Install the front seat. (Sedan model) Front Seat > INSTALLATION 15. Install each part of rear doors. (Sedan model) • Checker ASSY - rear door Tightening torque: 33 N·m (3.4 kgf-m, 24.3 ft-lb) • Rear door trim assembly • Rear speaker assembly 16. Connect the ground terminal to battery sensor. NOTE |
Selecting reverse gear
CAUTION
Shift into reverse ONLY when the
vehicle has completely stopped. It
may cause damage to the transmission
to try shifting into reverse when
the vehicle is moving.
1) Slider
You must raise the slider and hold it in that
position before you can move the shift
...