Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. SEDAN MODEL CAUTION: Make sure that there is a gasket attached on the clip of the garnish assembly. If a gasket is not attached, water leakage may occur. Install the side garnish assembly. 2. OUTBACK MODEL CAUTION: Make sure that there is a gasket attached on the clip of the garnish assembly. If a gasket is not attached, water leakage may occur. 1. Install the side garnish assembly. 2. Install the garnish assembly - door and the garnish assembly - rear quarter. (1) Remove the double-sided tape remaining on the vehicle body, then clean the adhesive surface. CAUTION: If even a slight amount of double-sided tape remains on the adhesive surface, it may lead to improper adhesion. (2) Heat the vehicle body and the garnish for 1 — 3 minutes using a heat light or a drier. CAUTION: Be careful not to burn yourself. (3) Apply primer to the installation surfaces of garnish, and wait till the primer dries. (4) Attach new double-sided tape on garnish. (5) Peel off the backing papers, engage the clips, and adhere the garnish assembly to the vehicle body. CAUTION: Press-fit the garnish assembly to adhere securely. |
Removal
1. SEDAN MODELRemove the clips and detach the side garnish assembly.2. OUTBACK MODEL1. Remove the clips and detach the side garnish assembly.(1)Double-sided tape(3)Garnish ASSY rear door(5)Side sill g ...
Sun visor
...
Other materials:
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel assembly - side (sedan model) or rear floor mat (OUTBACK model).• Sedan model: Trunk Room Trim > REMOVAL• OUTBACK model: Remove the rear floor mat and the spacer - rear floor mat.3. Lift up the ve ...
