1. Install the ball joint into the housing assembly - front axle. CAUTION: • Do not apply grease to the tapered portion of ball stud. • Before tightening, make sure the bottom surface of the housing assembly - front axle and the stepped section of ball joint are in contact.
Tightening torque: 50 N·m (5.1 kgf-m, 36.9 ft-lb) 2. Install the ball joint into front arm. (1) Connect the ball joint to the front arm. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) (2) Tighten the castle nut further up to 60° until the hole in the ball stud is aligned with a slot in castle nut. (3) Insert a new cotter pin and bend it around the castle nut. 3. Install the front wheels. Tightening torque: 120 N·m (12.2 kgf-m, 88.5 ft-lb) |
Reverse function
WARNING
Do not let parts of your body get
caught when operating the reverse
function. If the reverse
function does not operate for
some reason, this may lead to
serious injury or accidents.
The reverse function may not
operate if foreign objects are ...