Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Camshaft position sensor / Installation

1. Install the camshaft position sensor to the chain cover, and connect the connector to the camshaft position sensor.

NOTE:

• Use new O-rings.

• Apply engine oil to O-ring.

Tightening torque:

6.4 N·m (0.7 kgf-m, 4.7 ft-lb)

2. Install the air intake duct. (RH side only) Air Intake Duct > INSTALLATION

Inspection

1. CAMSHAFT POSITION SENSOR1. Disconnect the ground terminal from battery sensor. NOTE2. Prepare an oscilloscope.3. While pressing the section (A) shown in the figure, move the lock lever (B) in the ...

Crankshaft position sensor

...

Other materials:

Dtc b144a rear vent door actuator circuit stuck
DTC DETECTING CONDITION:Rear vent actuator is locked.TROUBLE SYMPTOM:Unable to control the rear vent temperature.WIRING DIAGRAM:Air conditioning system Air Conditioning System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK CONNECTOR.1) Check connecting condition of the A/C CM connector and rear vent actuato ...