1. Set the engine wiring harness to the engine, and connect the connector. NOTE: • If the clip is damaged, replace it with a new part. • Before replacing the clip, put an alignment mark (a) on both engine wiring harness and clip to remove the clip, and then align to the alignment mark (a) to attach a new clip to the engine wiring harness. • Structural diagram 1
• Structural diagram 2
2. Install the intake manifold assembly. Intake Manifold Assembly > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. SYSTEM INSPECTIONNOTE:• The wiper deicer does not operate when the ambient temperature becomes 5°C (41°F) or more.• The wiper deicer operates with the rear window defogger at the same time.• It is possible to perform a forced operation if you keep holding the rear ...