1. Install the knock sensor to the cylinder block, and connect the connector to the knock sensor. NOTE: • Install the knock sensor connector so that the center of the connector is aligned with the extension line from the cylinder block rib (a). • Make sure that the knock sensor and its connector do not touch the adjacent parts. Tightening torque: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
2. Install the bolt securing the connector to the A/C compressor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 3. Connect the ground terminal to battery sensor. NOTE |
Dtc p0107 manifold absolute pressure/barometric pressure sensor circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...