1. Install the crankshaft position sensor to the cylinder block, and connect the connector to the crankshaft position sensor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 2. Install the service hole plug. 3. Install the throttle body. Throttle Body > INSTALLATION 4. Install the air intake boot. Air Intake Boot > INSTALLATION 5. Connect the ground terminal to battery sensor. NOTE 6. Install the collector cover. |
Dtc p0455 evap system (cpc) leak detected (large leak)
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Fuel odor• There is a hole of more than 1.0 mm (0.04 in) dia. in evaporation system or fuel tank.• Fuel filler cap loose or lostCAUTION:After servicing or replacing faulty parts, ...