Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h6do) / Mass air flow and intake air temperature sensor / Installation

1. Install the mass air flow and intake air temperature sensor, and connect the connector to the mass air flow and intake air temperature sensor.

Tightening torque:

1 N·m (0.1 kgf-m, 0.7 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

Inspection

1. CHECK THE MASS AIR FLOW SENSOR UNIT1. Connect the battery positive terminal to terminal No. 3 and the battery ground terminal to terminal No. 4, and connect the circuit tester positive terminal to ...

Oil flow control solenoid valve

...

Other materials:

Inspection
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C).3. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.4. Disconnect the transmission radio ground terminal and transmission harness connector ...