Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: If lubricant is spilt over the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire. 1. Before installing rear oxygen sensor, apply the anti-seize compound only to the threaded portion of rear oxygen sensor to make the next removal easier. CAUTION: Never apply anti-seize compound to the protector of rear oxygen sensor. Anti-seize compound: NEVER-SEEZ NSN, JET LUBE SS-30 or equivalent 2. Install the rear oxygen sensor. Tightening torque: 21 N·m (2.1 kgf-m, 15.5 ft-lb)
3. Install the front exhaust pipe. Front Exhaust Pipe > INSTALLATION 4. Lower the vehicle. 5. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. Check that the rear oxygen sensor has no deformation, cracks or other damages.2. Measure the resistance between rear oxygen sensor terminals.Terminal No.Standard1 and 25.6+0.8 −0.6 - (when 20 ...
Throttle body
...
Other materials:
Dtc p0351 ignition coil "a" primary control circuit/open
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM: ...
