1. DRIVER’S SIDE 1. When replacing the actuator with a new part, apply a thin coat of grease evenly to the side face (a) of lever pin by using approx. 5 mm (0.2 in) width and approx. 0.1 g (0.004 oz) of grease squeezed out from a tube. NOTE: After installing the actuator, perform 3 — 5 times of adaptation for the grease to fit in. Grease: SUBARU genuine grease (Part No. 72129AJ000) 2. Install the motor - actuator mix. 3. Install the panel - knee guard. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 4. Install the cover assembly - instrument panel LWR driver. 5. Connect the ground terminal to battery sensor. NOTE 2. PASSENGER’S SIDE 1. When replacing the actuator with a new part, apply a thin coat of grease evenly to the side face (a) of lever pin by using approx. 5 mm (0.2 in) width and approx. 0.1 g (0.004 oz) of grease squeezed out from a tube. NOTE: After installing the actuator, perform 3 — 5 times of adaptation for the grease to fit in. Grease: SUBARU genuine grease (Part No. 72129AJ000) 2. Install the motor - actuator mix. 3. Install the pocket assembly and the back panel - pocket. 4. Connect the ground terminal to battery sensor. NOTE |
Convenient tie-down hooks (Outback)
CAUTION
The convenient tie-down hooks are
designed only for securing light
cargo. Never try to secure cargo
that exceeds the capacity of the
hooks. The maximum load capacity
is 110 lbs (50 kg) per hook.
The cargo area is equipped with four tiedown
hooks so that ca ...