CAUTION: After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct. 1. Install the switch - hazard. (Center grille assembly) 2. Install the grille assembly. 3. Install the end cover - console box. (Rear grille assembly) 4. Install the cover assembly - front and the console box assembly. (Rear grille assembly) Tightening torque: 6.5 N·m (0.7 kgf-m, 4.8 ft-lb) 5. Connect the ground terminal to battery sensor. NOTE |
Dtc p0616 starter relay "a" circuit low
1. MODEL WITHOUT PUSH BUTTON STARTDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIA ...