Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

CAUTION:

Do not start the engine before charging refrigerant.

If the engine is started with no refrigerant charge, replace the compressor assembly.

Make sure that the water seal packing on the cover attachment area is securely attached.

Replace the O-rings with new parts, and then apply compressor oil.

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION

1. Install the evaporator sensor at the position shown in the figure below.

(1)

Evaporator

(3)

47.7 mm (1.88 in)

(5)

50 mm (1.97 in)

(2)

Evaporator sensor

(4)

34.3 mm (1.35 in)

2. Install the evaporator assembly - cooling. Evaporator > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

4. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE

Inspection
1. Prepare the vehicle.NOTE:Check that the ambient temperature is 25 — 40°C (77 — 104°F) and that the humidity is 30% — 80%.• Place the vehicle in the workshop or in the shad ...

Expansion valve
...

Other materials:

Dtc b1434 evaporator temperature sensor circuit open
DTC DETECTING CONDITION:Evaporator sensor circuit is open.TROUBLE SYMPTOM:• Compressor does not operate.• Evaporator temperature is falsely recognized as low, and the compartment temperature is adjusted.WIRING DIAGRAM:Air conditioning system Air Conditioning System > WIRING DIAGRAMSTEPC ...

© 2017-2024 Copyright www.sulegacy.com