CAUTION: • Do not start the engine before charging refrigerant. • If the engine is started with no refrigerant charge, replace the compressor assembly. • Replace the gasket and O-rings with new parts, and then apply compressor oil. 1. Install the expansion valve - cooling. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 2. Install the hose - pressure suction and the pipe - evaporator cooling. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Connect the ground terminal to battery sensor. NOTE 4. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE |
Operating conditions
The Reverse Automatic Braking system
will operate when all of the following
conditions are met.
The ignition switch is in the "ON"
position
The EyeSight warning indicator is off
The RAB warning indicator is off
HALT (Reverse Automatic Braking
system OFF) indic ...