CAUTION: Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION 1. When replacing the actuator with a new part, apply a thin coat of grease evenly to the side face (a) of lever pin by using approx. 5 mm (0.2 in) width and approx. 0.1 g (0.004 oz) of grease squeezed out from a tube. NOTE: After installing the actuator, perform 3 — 5 times of adaptation for the grease to fit in. Grease: SUBARU genuine grease (Part No. 72129AJ000) 2. Install the motor - actuator blower. 3. Install the instrument panel assembly. Instrument Panel Assembly > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE |
Removal
1. Lift up the vehicle.2. Remove the wheels.3. Remove the clips, then remove the mud guard.(1)Air flap - front(3)Cover - fender LWR(5)Mud guard - rear(2)Mud guard - front(4)Air flap - rear ...