Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Do not start the engine before charging refrigerant. • If the engine is started with no refrigerant charge, replace the compressor assembly. • Replace O-rings and pipe clamps with new parts and install securely. • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION 1. Install the blower motor unit assembly. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the heater and cooling unit assembly. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the instrument panel assembly and the beam COMPL - steering. Instrument Panel Assembly > INSTALLATION 4. Attach the heater hose. 5. Install the hose - pressure suction and the pipe - evaporator cooling. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 6. Connect the ground terminal to battery sensor. NOTE 7. Fill engine coolant. • H4 model: Engine Coolant > REPLACEMENT • H6 model: Engine Coolant > REPLACEMENT 8. Charge refrigerant. Refrigerant Charging Procedure > PROCEDURE |
Removal
CAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION1. Disconnect th ...
Heater core
...
Other materials:
Installation
CAUTION:• Be careful of the following items. Failure to do so may cause the airbag system malfunction.– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “ ...
