1. When replacing the actuator with a new part, apply a thin coat of grease evenly to the contact area (a) inside the rail of link plate by using approx. 5 mm (0.2 in) width and approx. 0.1 g (0.004 oz) of grease squeezed out from a tube. Also apply a thin coat of grease evenly to the contact areas (b) through (f), by using the same amount of grease to each area. NOTE: After installing the actuator, perform 3 — 5 times of adaptation for the grease to fit in. Grease: SUBARU genuine grease (Part No. 72129AJ000) 2. Install the motor - actuator mode and the link plate to the cover - actuator. 3. Install the motor - actuator assembly. 4. Install the panel - knee guard. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 5. Install the cover assembly - instrument panel LWR driver. 6. Connect the ground terminal to battery sensor. NOTE |
Electrical specification
1. KEYLESS ACCESS CMTerminal No.ContentsMeasuring conditionStandard(i75) No. 1 ←> Chassis groundGroundAlways *1Less than 1 -(i75) No. 2 ←> 1Immobilizer signal reception (ignition switch)Wait for 30 seconds or more after the door was opened or closed with IG OFF and the brake pedal (except ...