1. Install the auto headlight beam leveler CM. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the relay holder. 3. Install the panel - knee guard. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 4. Install the cover assembly - instrument panel LWR driver. 5. Connect the ground terminal to battery sensor. NOTE 6. Perform initialization and reinitialization of the auto headlight beam leveler system. Auto Headlight Beam Leveler System > PROCEDURE |
To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
When setting the displayed unit as
"MPH":
The set speed can be decreased ...