CAUTION: • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION • Do not allow harness and connectors to interfere or get tangled up with other parts. • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position. • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT 1. Install the switch assembly - combination turn dimmer. 2. Install the switch assembly - combination wiper select. 3. Install the steering roll connector. Roll Connector > INSTALLATION 4. Install the cover assembly - column. 5. Install the steering wheel. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) Clearance: Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in) 6. Install the driver’s airbag module. Driver’s Airbag Module > INSTALLATION 7. Connect the ground terminal to battery sensor. NOTE |
Installation
1. SEDAN MODEL1. Install the rear turn signal light bulb. Rear Combination Light Assembly > ASSEMBLY2. Install the trunk trim panel - side.3. Connect the ground terminal to battery sensor. NOTE2. OUTBACK MODEL1. Install the rear turn signal light bulb. Rear Combination Light Assembly > ASSEMBLY2. ...