CAUTION: Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a). 1. Install the resistor assembly - daytime running light. CAUTION: Be careful not to allow the harness to interfere with vehicle body, etc. and prevent excessive force from being applied. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the bumper face - front. 3. Connect the ground terminal to battery sensor. NOTE 4. Adjust the front fog light beam. (Model with front fog light) Front Fog Light Assembly > ADJUSTMENT |
Dtc u0077 lin communication bus "ecm/pcm" off
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...