CAUTION: • Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a). • Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the engaging position is not correct, the flange section may be broken or the clearance between fender panel and bumper face may not be uniform. 1. Install the light assembly - head. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the bracket - front bumper corner. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the cover - front fender UPR. 4. Install the bumper face - front. Front Bumper > INSTALLATION 5. Connect the ground terminal to battery sensor. NOTE 6. Adjust the headlight beam and fog light beam. • Adjust the headlight beam. Headlight Assembly > ADJUSTMENT • Adjust the fog light beam. (Model with fog light) Front Fog Light Assembly > ADJUSTMENT |
Dtc p2404 evap system leak detection pump sense circuit range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...