Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Light control sensor / Installation

1. Install the sensor - automatic light.

2. Install the duct - front defroster.

3. Install the grille speaker side.

4. Install the trim panel - front pillar UPR. Upper Inner Trim > INSTALLATION

5. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Connect the connector.2. Turn the ignition switch to ON, and set the lighting switch to the AUTO position.3. Measure the voltage between connector terminals.Preparation tool:Circuit testerTerminal ...

Luggage room light

...

Other materials:

Dtc p0021 "a" camshaft position - timing over-advanced or system performance bank 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine stalls.• Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCE ...