Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Rear combination light assembly / Installation

1. SEDAN MODEL

1. Replace the light assembly gasket with a new part.

2. Install the light assembly - rear combination.

CAUTION:

Be careful not to catch the harness in between the parts.

Tightening torque:

4.5 N·m (0.5 kgf-m, 3.3 ft-lb)

3. Install the trunk trim panel - side.

4. Connect the ground terminal to battery sensor. NOTE

2. OUTBACK MODEL

1. Install the light assembly - rear combination.

CAUTION:

Be careful not to catch the harness in between the parts.

Tightening torque:

7.5 N·m (8.0 kgf-m, 5.5 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

Assembly

CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.1. TURN SIGNAL LIGHT BULB1. Install the turn signal light bulb.2. Install the bulb socket.2. SIDE MARK ...

Inspection

1. Apply battery voltage between the connector terminals to check the lighting condition of the light.• Sedan modelTerminal No.Inspection conditionsSpecification3 (+) — 2 (−)Apply batter ...

Other materials:

Dtc b1650 occupant detection system malfunction
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Occupant detection sensor malfunction, communication failure between airbag CM and occupant detection sensor, rear harness malfunction, seat harness malfunction, blown out of fuse for occupant detection systemCAUTION: ...