1. Install the sensor assembly - headlight beam leveler. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the rear wheels. Tightening torque: 120 N·m (12.2 kgf-m, 88.5 ft-lb) 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE 5. Perform reinitialization of the auto headlight beam leveler system. Auto Headlight Beam Leveler System > PROCEDURE NOTE: When replacing the rear vehicle height sensor with a new part, perform the initialization. Auto Headlight Beam Leveler System > PROCEDURE |
Rear center seatbelt on Outback
Center seatbelt tongue plate
Connector (tongue)
Connector (buckle)
Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing
twisted can increase the risk or
severity of injury in an accident.
When fastening the belt after it is
...