Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. Install the lens and bulb.

CAUTION:

Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.

2. Install the light assembly - room.

3. Connect the ground terminal to battery sensor. NOTE

Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 3Switch OFF1 M- or moreSwitch ONLess than 1 -2 — 3Switch doorLess ...

Side turn signal light assembly
...

Other materials:

Dtc p2097 post catalyst fuel trim system too rich bank 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...

© 2017-2024 Copyright www.sulegacy.com