Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the oil level switch, and install the clip (A) to the oil pan upper. NOTE: • Use new O-rings. • Apply a coat of engine oil to the O-rings. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
2. Attach the clip (A) securing the harness, and connect the connector of the oil level switch to the engine harness.
3. Install the under cover. Front Under Cover > INSTALLATION 4. Lower the vehicle. 5. Connect the ground terminal to battery sensor. NOTE 6. Fill engine oil. Engine Oil > REPLACEMENT |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the under cover. Front Under Cover > REMOVAL3. Drain the engine oil. Engine Oil > REPLACEMENT4. Disconnect the oil level switch ...
Other materials:
Locking and unlocking from the outside
NOTE
If you unlock the driver's door with a
key (including a mechanical key) and
open the door while the alarm system
is armed, the alarm system is triggered
and the vehicle's horn sounds. In this
case, perform any of the following
operations:
Models with "keyless access with
push-button st ...
