Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. Install the transfer drive gear.

Tightening torque:

26 N·m (2.7 kgf-m, 19.2 ft-lb)

2. Install the transfer driven gear. Transfer Driven Gear > INSTALLATION

3. Select the adjusting washer. Transfer Case and Extension Case Assembly > INSTALLATION

4. Install the transfer case and the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION

5. Install the back-up light switch and the neutral position switch. Switches and Harness > INSTALLATION

6. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION

Assembly
1. Install the needle bearing and snap ring to the transfer drive gear.2. Set the ST to the ball bearing inner race, then install the transfer drive gear.CAUTION:Do not apply a load in excess of 10 kN ...

Inspection
1. Ball bearingReplace the ball bearing in following cases.• In case of broken or rusty ball bearings• In case of worn or damaged ball bearings• When the ball bearings fail to turn s ...

Other materials:

Electrical component location location
(1)VDC control module and hydraulic control unit (VDCCM&H/U)(6)Brake light relay(10)Hill hold switch(2)VDC OFF switch(7)Magnetic encoder(11)Engine control module (ECM)(3)Combination meter(8)ABS wheel speed sensor(12)Transmission control module (TCM) (engine type FB)(4)Steering angle sensor(9)Parking ...

© 2017-2024 Copyright www.sulegacy.com