1. CROSSMEMBER AND CUSHION RUBBER 1. Install the transmission cushion rubber to the transmission, and tighten the bolt (A). 2. Install the transmission cushion rubber to the center crossmember, and temporarily tighten the nut (B). Tightening torque: Bolt (A) 35 N·m (3.6 kgf-m, 25.8 ft-lb) 3. Install the front crossmember and rear crossmember. 4. Tighten the transmission cushion rubber mounting nut. Tightening torque: T1: 75 N·m (7.6 kgf-m, 55.3 ft-lb) T2: 140 N·m (14.3 kgf-m, 103.3 ft-lb) T3: 35 N·m (3.6 kgf-m, 25.8 ft-lb) 5. Remove the transmission jack. 6. Install the center exhaust cover. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 7. Install the center exhaust pipe (rear). Center Exhaust Pipe > INSTALLATION 8. Install the front under cover. Front Under Cover > INSTALLATION 9. Lower the vehicle. 10. Connect the ground terminal to battery sensor. NOTE |
Inspection mode procedure
1. VDC SYSTEM1. Delete the DTC.2. Drive the vehicle at least ten minutes. (Reproduce nearly the same condition as occurred when the DTC was recorded.)NOTE:Make sure the vehicle is not dragged to one side under usual driving condition.2. ELECTRONIC PARKING BRAKE SYSTEM1. Start the engine, and operate ...