Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Mechanical(h4do) / V-belt / Installation

1. V-BELT

1. Attach the tool to the V-belt tensioner assembly, and rotate the tool clockwise to remove the V-belt as shown in the figure.

CAUTION:

• When reusing the V-belt, wipe off dust and water with cloth.

• Do not use the V-belt if there is any oil, grease or coolant on the belt.

• Be careful not to rub the V-belt end surface with bare hands; exposed core may cause injury.

• Wipe off any dust, oil and water on the groove of each pulley with cloth.

(A)	V-belt	(D)	V-belt tensioner ASSY	(G)	A/C compressor pulley
(B)	Water pump pulley	(E)	Generator pulley
(C)	Crank pulley	(F)	Idler pulley

2. When working on the vehicle

NOTE:

When working on the vehicle, perform the following steps also.

(1) Install the V-belt cover.

Tightening torque:

6.5 N·m (0.7 kgf-m, 4.8 ft-lb)

2. V-BELT TENSIONER ASSEMBLY

1. Install the V-belt tensioner assembly.

NOTE:

When installing the V-belt tensioner assembly, insert the protrusion of V-belt tensioner assembly into the hole for preventing rotation at the generator bracket.

(A)	V-belt tensioner ASSY	(C)	Hole to prevent rotation	(D)	Protrusion portion
(B)	Generator bracket

Tightening torque:

25 N·m (2.5 kgf-m, 18.4 ft-lb)

2. Install the V-belts. V-belt > INSTALLATION

3. IDLER PULLEY

1. Install the idler pulley.

NOTE:

When installing the idler pulley, be careful of the idler pulley cover direction.

(A)

Idler pulley cover

(B)

Protrusion (3 places)

Tightening torque:

36 N·m (3.7 kgf-m, 26.6 ft-lb)

2. Install the V-belts. V-belt > INSTALLATION

Inspection

1. Check the V-belt for cracks, tear or wear.2. Check the V-belt tensioner assembly and idler pulley for deformation, cracks or other damages.3. Check that the V-belt ribs are securely placed on the r ...

Mechanical(h6do)

...

Other materials:

Dtc p0327 knock/combustion vibration sensor 1 circuit low bank 1 or single sensor
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Poor driving performance• Knocking occursCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM: ...