1. Apply liquid gasket to the mating surfaces of the cylinder block, cylinder head and oil pan upper as shown in the figure. Liquid gasket: THREE BOND 1217G (Part No. K0877Y0100), THREE BOND 1217H or equivalent 2. Apply liquid gasket to the mating surface of the chain cover. NOTE: • Before applying liquid gasket, degrease the old liquid gasket seal surface of the engine and chain cover. • Install within 5 min. after applying liquid gasket. Liquid gasket: THREE BOND 1217G (Part No. K0877Y0100), THREE BOND 1217H or equivalent Liquid gasket applying diameter: 3.5±0.5 mm (0.138±0.020 in) 3. Attach the chain cover and temporarily tighten the chain cover installation bolts. CAUTION: Do not install the chain cover installation bolts in wrong place.
4. Tighten the chain cover installing bolts in the numerical order as shown in the figure. Tightening torque: 10 N·m (1.0 kgf-m, 7.4 ft-lb) 5. Install the oil cooler pipe to the chain cover. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 6. Install the crank pulley. Crank Pulley > INSTALLATION 7. Install the V-belts. V-belt > INSTALLATION 8. Fill engine oil. Engine Oil > REPLACEMENT 9. When working on the vehicle NOTE: When working on the vehicle, perform the following steps also. (1) Install the engine mount. Engine Mounting > INSTALLATION (2) Install the front exhaust pipe. Front Exhaust Pipe > INSTALLATION (3) Install the radiator. Radiator > INSTALLATION |
Dtc c2511 torque sensor main
DTC DETECTING CONDITION:When torque sensor main output voltage failure is detected after the ignition switch is ON.TROUBLE SYMPTOM:• The steering wheel operation feels heavy.• STEERING warning light illuminates.WIRING DIAGRAM:Electric power steering system Electric Power Steering System ...