Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. Clean the crankshaft thread using compressed air.

2. Install the crank pulley.

3. Apply engine oil to the crank pulley bolt seat and thread.

4. Use the ST to lock the crank pulley, and tighten the crank pulley bolt.

NOTE:

After tightening, if engine oil is spilt onto the crank pulley bolt or the crank pulley, wipe it off with a cloth.

ST1 18355AA000PULLEY WRENCH
ST2 18334AA000PULLEY WRENCH PIN SET

Tightening torque:

195 N·m (19.9 kgf-m, 143.8 ft-lb)

5. Install the V-belts. V-belt > INSTALLATION

Inspection
Check that the crank pulley has no deformation, cracks or other damages. ...

Crank sprocket
...

Other materials:

Installation
CAUTION:• Be careful not to damage the sensor.• Do not apply excessive force to the sensor harness.1. Install the rear ABS wheel speed sensor.NOTE:Check the identification (mark) on the harness to make sure there is no warpage. General Description > SPECIFICATIONTightening torque:Rear A ...

© 2017-2024 Copyright www.sulegacy.com