CAUTION: • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position. • If the steering wheel and steering angle sensor are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT 1. Align the center position of the roll connector. Roll Connector > ADJUSTMENT 2. Install the steering wheel. Tightening torque: Steering wheel: 39 N·m (4.0 kgf-m, 28.8 ft-lb) Clearance: Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in) 3. Install the driver’s airbag module. Driver’s Airbag Module > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE |
Removal
1. FRONT ANTENNACAUTION:Do not detach the antenna from the front door outer handle.If replacement is required, replace the front outer handle assembly as a whole.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the handle - door outer. Front Outer Handle > REMOVAL2. REAR ANTENN ...