1. Install the power rear gate drive unit (PRG D/U). Tightening torque: 25 N·m (2.5 kgf-m, 18.4 ft-lb) 2. Install the trim panel - rear apron LH and trim panel - rear quarter trim UPR rear LH. 3. Install the rod - power rear gate. Power Rear Gate Rod > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE |
Installation
1. Install the differential side retainers using ST.ST 18630AA010WRENCH COMPL RETAINER2. Install the taper roller bearing outer race to the transmission case.3. Install the front differential assembly.CAUTION:Make sure the oil seal lip is not folded.4. Install the main shaft assembly. Main Shaft ...