Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. SEAT BELT OUTER - FRONT

CAUTION:

Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION

The parts of the driver and passenger sides are not the same. Before installation, make sure that the correct part is used.

During installation, make sure that the seat belts are not twisted.

After installation, make sure that the seat belt can be pulled out and retracted smoothly.

Make sure that the seat belt harness is not caught anywhere. Wrong harness rooting may cause the harness short from pinch.

If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat.

1. Before installation, perform a unit inspection of retractor. Front Seat Belt > INSPECTION

2. Install the adjuster assembly - seat belt and the seat belt outer - front.

Tightening torque:

Refer to “COMPONENT” of “General Description”. General Description > COMPONENT

3. Install the trim panel - rear pillar UPR.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

4. Install the trim panel - center pillar LWR, cover side sill - front, and cover side sill - rear.

5. Install the rear seat cushion assembly.

6. Connect the ground terminal to battery sensor. NOTE

7. After installation, check the following points.

The seat belt is not twisted.

The seat belt can be pulled out and retracted smoothly.

The adjuster assembly - seat belt can be moved smoothly.

Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the battery ground cable and turning the ignition switch to ON.

2. SEAT BELT INNER - FRONT

CAUTION:

Before installation, make sure that the correct part is used.

During installation, make sure that the seat belts are not twisted.

Check that there is no pinching of the seat belt harness. Wrong harness rooting may cause the harness short from pinch.

Do not forget the wave washer, when installing front seat inner belt assembly.

1. Install the seat belt inner - front.

Tightening torque:

53 N·m (5.4 kgf-m, 39.1 ft-lb)

2. Install the seat assembly to the body. Front Seat > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

Inspection
1. VISUAL INSPECTIONCheck for the following, and replace with new parts if necessary.• Pretensioner is cracked or deformed.• Adjuster assembly - seat belt is cracked or deformed.• Se ...

General description
...

Other materials:

Inspection mode procedure
It is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded.1. PREPARATION FOR THE INSPECTION MODE1. Check that the battery voltage is 12 V o ...

© 2017-2024 Copyright www.sulegacy.com