Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Front door latch and door lock actuator assembly / Installation

1. Before installation, check the following items.

• Cable and rod are free from deformation.

• Grease is applied sufficiently to rod joints.

If grease is insufficient, add it as necessary before assembling the rod.

2. Install the latch and actuator assembly - front.

CAUTION:

Do not re-use the screws. Always replace with a new part.

Tightening torque:

6.5 N·m (0.7 kgf-m, 5.2 ft-lb)

3. Install the rod clamp to the frame assembly - front door outer.

4. Install the sash COMPL - lower.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

5. Install the sealing cover - front door.

6. Install the trim panel - front door. Door Trim > INSTALLATION

7. Connect the ground terminal to battery sensor. NOTE

Inspection

1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly - front.2. LOCK ACTUATOR1. Check door lock operationCheck the door lock operation when ...

Front hood lock assembly

...

Other materials:

Dtc p2098 post catalyst fuel trim system too lean bank 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...