Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Impact sensor / Installation

1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.

2. Close all the doors, trunk lid and rear gate.

3. Press the UNLOCK button of the keyless transmitter or access key.

4. Connect the ground terminal to battery sensor. NOTE

5. Install the impact sensor.

6. Change the setting of impact sensor using Subaru Select Monitor.

Operation

1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR1. Make an impact monitor setting.(1) Connect the Subaru Select Monitor to data link connector.NOTE:For detailed operation procedures, refer to &ldq ...

Key lock cylinders

...

Other materials:

Electrical component location location
1. ENGINE COMPARTMENT(1)Pressure sensor(2)A/C compressor(Refrigerant flow sensor, variable flow change solenoid)(3)Ambient sensor2. PASSENGER COMPARTMENT(1)Evaporator sensor(5)Sunload sensor(9)A/C control panel(2)Air mix door actuator*1 or air mix door actuator LH*2(6)Intake door actuator(10)Air mix ...