1. STEERING LOCK 1. Install the key cylinder. 2. Install the key lock solenoid and immobilizer antenna assembly. 3. Install the cover assembly - column. 4. Connect the ground terminal to battery sensor. NOTE 2. FRONT DOOR 1. Install the key cylinder. 2. Install the cover - handle front outer. CAUTION: When installing the cover - handle front outer on driver’s side, make sure that the key cylinder shaft is correctly inserted into the latch & actuator assembly - front. Preparation tool: TORX® T30 Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. TRUNK LID 1. Install the key cylinder. 2. Install the trunk lid garnish. Trunk Lid Garnish > INSTALLATION 4. GLOVE BOX LID 1. Install the key cylinder. 2. Install the pocket assembly. |
Installation
1. REAR HEATER DUCTCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION1. Install the duct - rear heater.2. Install the floor mat. Floor Mat > INSTALLATION3. Connect t ...