Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
NOTE: Make sure the child safety lock works correctly after installation. 1. Before installation, check the following items. • Cable is free from deformation. • Grease is applied sufficiently to lever joints. If grease is insufficient, add it as necessary before assembling. 2. Install the latch and actuator assembly - rear. CAUTION: Do not re-use the screws. Always replace with a new part. Tightening torque: 6.5 N·m (0.7 kgf-m, 5.2 ft-lb) 3. Install the glass assembly - rear door. Rear Door Glass > INSTALLATION 4. Install the sealing cover - rear door. 5. Install the trim panel - rear door. Door Trim > INSTALLATION 6. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. LATCHCheck if the latch operates normally.If the cable is faulty, replace the latch & actuator assembly - rear.2. ACTUATOR1. Check door lock operationCheck the door lock operation when battery volt ...
Other materials:
Dtc c1742 wheel cylinder pressure sensor
DTC DETECTING CONDITION:• A fault is detected if the condition that supply voltage for the fluid pressure sensor is out of normal judgment range continues for predetermined time.• A fault is detected if the communication status of fluid pressure sensor is abnormal.• A fault is dete ...
