1. Install the latch and actuator - rear gate. Tightening torque 25 N·m (2.5 kgf-m, 18.4 ft-lb) 2. Install the trim panel - rear gate. Rear Gate Trim > REMOVAL 3. Connect the ground terminal to battery sensor. NOTE |
Entering the vehicle following remote engine start
shutdown
An alarm trigger may occur if the vehicle is
opened by the remote keyless entry
system/keyless access function within a
few seconds immediately following remote
engine start shutdown.
Pre-heating or pre-cooling the interior of the
vehicle
Before exiting the vehicle, set the temperature
cont ...