Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Steering lock cm / Installation

CAUTION:

• Registration of the immobilizer is necessary when a immobilizer-related control module has been replaced. For the relevant procedures, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER”.

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION

• Do not allow harness and connectors to interfere or get tangled up with other parts.

• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT

1. Secure the steering lock CM to the steering column.

2. Use new set bolts. Tighten the bolt until the bolt head is broken (bolt head wrenched off).

3. Install the column assembly - steering.

4. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Check if the steering lock is released when you start the engine using the push button ignition switch.2. If the system does not operate normally as the result of inspection, refer to “Genera ...

Trunk lid latch and actuator assembly

...

Other materials:

List
• List of freeze frame dataDisplayContentUnitECU Power Supply Voltage (IG)Display of input voltage of stereo cameraVEngine SpeedEngine speedrpmAccel opening angleAcceleration opening angle signal%Brake Fluid Target PressureTarget value of brake fluid pressureMPaMaster Cylinder Actual Fluid Pre ...