CAUTION: • Be careful not to damage the sensor. • Do not apply excessive force to the sensor harness. 1. Install the rear ABS wheel speed sensor. NOTE: Check the identification (mark) on the harness to make sure there is no warpage. General Description > SPECIFICATION Tightening torque: Rear ABS wheel speed sensor: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the grommet, and connect the rear ABS wheel speed sensor connector. 3. Install the trunk trim panel assembly - side (sedan model) or rear floor mat (OUTBACK model). • Sedan model: Trunk Room Trim > INSTALLATION • OUTBACK model: Install the rear floor mat and the spacer - rear floor mat. 4. Install the rear wheels. Tightening torque: Rear wheel: 120 N·m (12.2 kgf-m, 88.5 ft-lb) 5. Lower the vehicle. 6. Connect the ground terminal to battery sensor. NOTE |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. While pressing the section (A) shown in the figure, move the lock lever (B) in the direction of the arrow to disconnect the connectors from the ECM in numerical order as shown in the figure.3. Remove the ECM from the ECM bracket.4. Disco ...