1. Install the air intake boot, and connect the PCV hose. 2. Tighten the clamp (C) securing the throttle body to the air intake boot. Tightening torque: 3 N·m (0.3 kgf-m, 2.2 ft-lb) 3. Tighten the clamp (B) securing the air cleaner case (rear) to the air intake boot. Tightening torque: 3 N·m (0.3 kgf-m, 2.2 ft-lb) 4. Install the clip (A) to the air intake boot. |
Installation
CAUTION:• When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim pan ...