1. Install the starter to the transmission. NOTE: Tighten the starter and bracket (a) together using the upper bolt securing the starter. Tightening torque: 50 N·m (5.1 kgf-m, 36.9 ft-lb) 2. Connect the connector (A) to the starter, and install the terminal (B). Tightening torque: 10 N·m (1.0 kgf-m, 7.4 ft-lb) 3. Install the air intake boot. Air Intake Boot > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE 5. Install the collector cover. |
Removal
1. PRE-COLLISION BRAKE OFF SWITCH1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Release the claws and remove the pre-collision brake OFF switch (h).2. LANE DEPARTURE WARNING OFF SWITCH1 ...