1. Install the EGR pipe adapter to the EGR control valve. NOTE: Use a new gasket. Tightening torque: 19 N·m (1.9 kgf-m, 14.0 ft-lb) 2. Install the EGR control valve to the intake manifold assembly, and connect the connector to the EGR control valve. Tightening torque: 19 N·m (1.9 kgf-m, 14.0 ft-lb) 3. Install the bolts securing the EGR cooler to the EGR control valve. Tightening torque: 9 N·m (0.9 kgf-m, 6.6 ft-lb) NOTE: Use a new gasket. 4. Tighten the bolts holding the EGR cooler to the cylinder head RH. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 5. Install the EGR pipe. EGR Pipe > INSTALLATION 6. Install the air intake boot. Air Intake Boot > INSTALLATION 7. Connect the ground terminal to battery sensor. NOTE |
Preparation for overhaul procedure
1. Clean oil, grease, dirt and dust from the transmission.2. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.3. Tighten the drain plug using TORX® bit T70.NOTE:Use a new gasket.Tightening torque:44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, ...