1. Install the purge control solenoid valve, and connect the connector and vacuum hose to the purge control solenoid valve. NOTE: Connect the vacuum hose as shown in the figure.
Tightening torque: 19 N·m (1.9 kgf-m, 14.0 ft-lb) 2. Install the air intake boot. Air Intake Boot > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE 4. Install the collector cover. |
Removal
1. Lift up the vehicle, and then remove the front wheels.2. Remove the nut - axle.CAUTION:Do not loosen the nut - axle while the front axle is loaded. Doing so may damage the hub unit COMPL.(1) Lift the crimped section of the nut - axle.(2) Remove the nut - axle using a socket wrench while depressin ...