1. Check that the mark on the cap - pivot wiper faces up. 2. Install the motor assembly - rear wiper. (1) Install the bolts, and install the motor assembly - rear wiper. Tightening torque: 6 N·m (0.6 kgf-m, 4.4 ft-lb) (2) Install the harness connector of the motor assembly - rear wiper. 3. Install the arm assembly - rear wiper. (1) Install the nuts, and install the arm assembly - rear wiper. Tightening torque: 8 N·m (0.8 kgf-m, 5.9 ft-lb) (2) Install the cover - rear wiper arm. 4. Install the rear gate trim. Rear Gate Trim > INSTALLATION 5. Connect the ground terminal to battery sensor. NOTE |
Removal
1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - trunk lid. Trunk Room Trim > REMOVAL3. Remove the garnish - trunk. Trunk Lid Garnish > REMOVAL4. Remove the rearview camera assembly.CAUTION:Do not drop or apply any impact to the rearview camera b ...