Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. MAIN SWITCH

CAUTION:

After installing the switch - power window main, always perform the initial setting.

Failure to do so may cause the improper activation of auto-reverse operation for pinching hazard prevention.

Use protective paper to avoid damage to the trim panel.

1. Install the panel - power window main switch to the trim panel - front door.

2. Install the trim panel - front door. Door Trim > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

4. Perform initial setting operation (reset operation A). Power Window System > OPERATION

2. SUB-SWITCH

CAUTION:

Use protective paper to avoid damage to the trim panel.

Switch - power window sub front

For installation of the switch - power window sub front on the passenger’s seat, refer to the installation procedure of the switch - power window main. Power Window Control Switch > INSTALLATION

Switch - power window sub rear

1. Install the panel - power window sub switch rear to the trim panel - rear door.

2. Install the trim panel - rear door. Door Trim > INSTALLATION

3. Connect the ground terminal to battery sensor. NOTE

Inspection
1. MAIN SWITCH• Driver’s seat (model with AUTO)CAUTION:• Since the switch - power window main is controlled by CPU, do not check continuity for switch alone with the circuit tester. ...

Power window system
...

Other materials:

Inspection
Operating condition:Radiator fan operates depending on the radiator fan speed related to engine coolant temperature or the radiator fan speed related to A/C compressor load, whichever is higher as a load condition.• Radiator fan speed related to engine coolant temperature(A)Radiator fan speed ...

© 2017-2024 Copyright www.sulegacy.com